- 1
Measure and cut out a square piece of plywood, 5.5 feet by 1.5 feet Lay a straight-edge diagonally on the square piece of plywood and cut the square piece into the two triangle side-pieces of the ramp. - 2
Cut the two 8-foot 2 x 4s in half, making four 4-foot pieces to connect the ramp sides. Position the two bottom 2 x 4's into place---one flush in the back corners and one just before the side triangles front tip keeping the 2 x 4 under the side angle. - 3). Use the drill to screw two 2.5-inch screws through the side plywood triangles into each end of the 2 x 4s. Position the top 2 x 4s in the top corners and one in the middle of the side triangles, and screw each into place with two screws on each side.
- 4). Measure and cut out a square piece of plywood 4 feet 1.5 inches by 5 feet 8.4 inches. Position the square piece of plywood on top of the ramp and use six 2-inch screws to screw the plywood edges into the triangle plywood sides of the ramp. Then use six 2-inch screws to screw the plywood to the three 2 x 4s on the top of the ramp.
SHARE
