- 1). Repair any serious damage. If the boards under your sink show water damage, they will need to be torn out and replaced. You can do this with a hammer or a hacksaw if necessary. Pull out the old boards, and cut a new piece of plywood to fit in the space. Screw this plywood into the cabinet frame. While you are there, check for any sink leakage to make sure this problem does not happen again. If you notice any water dripping, tighten up the pipe joints or call a plumber if the problem appears serious.
- 2). Remove the cabinet doors. Use a screwdriver to remove the doors from their hinges. Place all hardware in a plastic bag to keep it all together. Remove any interior contents from the cabinetry.
- 3). Sand the doors and cabinet frame. Use a medium grade sandpaper to remove the finish off of the wood. If you will be stripping the cabinets down to the bare wood, you may need to use a chemical wood stripper or heat gun. Wipe down the cabinet frame and doors, and re-sand with a fine grade of sandpaper.
- 4). Apply the first coat of paint or stain. Place the cabinet doors on a flat surface to minimize drips. Apply a thin coat of paint or stain to both the doors and the cabinet frame. Allow this plenty of time to dry. If staining, go over the surface with fine sandpaper before adding a second coat. For the doors, flip them over and do the opposite side once the first side is dry. Apply as many coats as necessary.
- 5). Apply a finish to the doors and cabinet frame. If you stained the wood, you will need to protect it with a clear coat of polyurethane. Apply one thin coat and allow it to dry. Sand this lightly, and then apply a second coat. Give the doors and frame at least six to eight hours to dry.
- 6). Re-attach the doors. Once everything is dry, put the doors back on the cabinet.
SHARE
