- 1). Examine the landscape block adhesive label to determine if the adhesive is latex or solvent based. Most exterior landscape block adhesives are solvent based.
- 2). Wash the latex-based adhesive-covered area with soap and warm water. Scrub the area gently with a soft-bristled scrub brush. Continue to scrub until no landscape adhesive remains.
- 3). Coat the solvent-based, adhesive-coated area of skin generously with baby oil, petroleum jelly or olive oil. If the solvent-based adhesive is bonding fingers or hands together, place your hands in a plastic container and pour baby oil or olive oil over your hands until the oil covers the adhesive. Allow the oil or petroleum jelly to soak into the skin for 10 to 15 minutes.
- 4). Rub a soft-bristled scrub brush over the oil-soaked adhesive to scrape it off the skin. If adhesive bonds hands or fingers together, gently separate your fingers or hands without pulling at the skin. If the body parts separate easily, scrub them with a scrub brush. If they do not separate easily, continue to soak them until separation is effortless.
- 1). Position a thin-bladed chisel onto the seam line between the two surfaces. Begin at the right or left end of the masonry, wood or metal surface.
- 2). Tap the handle of the chisel with a mallet to force it between the two surfaces. Insert a thin-bladed screwdriver into the gap created by the chisel to hold open the gap.
- 3). Pull the chisel out and move it slightly toward the center. Tap the chisel's handle with a mallet to pry open another small gap. Insert a second flat-bladed screwdriver to act as a wedge and keep open the gap. Continue to pry apart the two surfaces with this method until you are able to free them.
- 4). Apply a thick coating of petroleum jelly to the adhesive, and allow it to soak in for one to two hours. Scrape the remaining landscape block adhesive off the surfaces with a broad-bladed metal putty knife.
Skin
Surfaces
SHARE