Metal Trim

• 1). Center the metal trim between the bottom front edges of the oven cabinet.
  
  
• 2). Inscribe the outline and center point of each the two horizontal slots on either side of the trim with a sharp pencil.
  
  
• 3). Remove the trim and drill two 3/16 inch pilot holes into the cabinet through the center point on the two oval marks with a cordless drill/driver.
  
  
• 4). Place the metal trim in the bottom opening and center the horizontal slots on the pilot holes. Attach the edges of the trim to the cabinet with masking tape to maintain its alignment.
  
  
• 5). Secure the trim to the cabinet with the drill/driver and the two mounting screws provided in the kit.
  
  

Plastic Trim

• 1). Center the bottom plastic trim inside the opening; ensure that the flat side of the trim is uppermost.
  
  
• 2). Locate the two keyhole slots on the back of the trim and slide them over the two end rivets protruding from the bottom front of the oven.
  
  
• 3). Push the plastic trim inward and downward until it snaps into place.