- 1). Unplug the Frigidaire Ultra Quiet III dishwasher if it is plugged in.
- 2). Plan the drain line to the sink or disposal. If the line will be run through a cabinet, place a mark on the cabinet where you need to cut through.
- 3). Use the jigsaw to cut 2-inch holes for the drain hose. Start the hole in the cabinet with the drill to make a hole big enough for the jigsaw blade. Sand down any rough edges around the holes.
- 4). Feed the drain hose through the holes.
- 5). Connect the drain to an air gap, if required by local codes. If no air gap is required, the middle portion of the hose should be secured underneath the sink so that it is higher than the entry point on the tailpiece. This prevents the dirty water from being siphoned into the water supply.
- 6). Connect the end of the drain hose to either the sink trap or the garbage disposal. If connecting to the garbage disposal, use the 1-inch wide rubber connector at the end. If connecting to a sink trap, trim down the middle portion of the drain hose to the 5/8- or 3/4-inch connections as appropriate. Secure the drain hose with a hose clamp.
SHARE
