- 1). Unscrew the dash bezel from the dashboard using the Phillips screwdriver. There's one near the a/c controls and another pair above the gauge cluster.
- 2). Pull out the dash bezel with your hands. There are a few clips on the sides that need to be pulled out with mild pressure.
- 3). Remove the wiring cluster from the dashboard using the 1/4-inch ratchet, sockets and extension and unplug the harness from the gauge cluster using your hands.
- 4). Plug the stock harness into the replacement cluster using your hands.
- 5). Bolt the new cluster into the dash using the 1/4-inch ratchet, sockets and extension.
- 6). Install the dash bezel using your hands and the Phillips screwdriver.
- 7). Turn on the car and drive it around the block to make sure that the gauge sweeps correctly.
SHARE
