- 1). Open the GameCube console cover. Use your Gamebit to unscrew the deep screws securing the cover.
- 2). Remove the laser unit by unscrewing it with your Phillips screwdriver. Then carefully pull it out and set it aside. This allows you to easily access the inner wiring of the console.
- 3). Solder the wires to the mod chip with the solder and soldering iron. Each wire (purple, red, black and yellow) solders to the matching color on the mod chip. Soldering the first three wires is simple and only takes a few minutes. However, you must solder the yellow wire under the heat-sink which takes a little more time.
- 4). Connect the blue harness cables (comes with mod chip) to your mod chip and the power PCB connector in your GameCube. The ends of the cables can only insert into one place in the machine, so the proper inserts are easy to locate. This step allows your copied games to bypass lid detection, thus becoming playable on your system.
- 5). Program the mod chip with a new bios. Connect the external programmer (comes with mod chip) to your computer and follow the instructions that flash on screen. After programming, you can begin copying your game collection.
SHARE
