- 1). Open the glove box, and remove the two locking mechanisms from each side of the glove box. Unscrew the left, middle and right screws from the box. Close the glove box.
- 2). Pull off the access panel on the right side of the glove box. Unscrew the two screws located behind the panel. Remove the center access panel (under the radio), and unscrew the screw that is located on the right side of the area behind the panel.
- 3). Pull off the access panel located under the glove box. Unscrew the two screws that are located on the underside of the glove box. Unscrew the screw located on the metal bar.
- 4). Pull out the glove box, disconnecting the glove box light from the wire on the left side as you do so.
- 5). Unscrew the two screws on the ends of the metal bar, and remove it. You should now be able to see the air filter access door. Pull it open, and remove.
- 6). Remove the first air filter from the housing, and slide the second filter into the slot to remove it. Put in the replacement filters.
- 7). Reverse Steps 1 through 5 to finish the installation.
SHARE