- 1). Cut PVC pipe into eight 15-inch sticks. It is important to clean up the burs of the cut edges.
- 2). Cut four 12-inch sticks out of the remaining PVC pipe.
- 3). Screw the 1/2-inch male adapters into side inlet adapters.
- 4). Insert the 12-inch sticks into the female end of the male adapter.
- 5). Insert the remaining stick into each 1/2 elbow to create a cube. At this point your frame is complete.
- 1). Cut the nylon into 16 x 16 inch squares.
- 2). Using the fabric tape, place a strip of tape on all sticks.
- 3). In a smooth motion, press the edge of the nylon fabric square to the adhesive on the stick. Repeat steps 2 and 3 around the square.
- 4). Once you have one fabric square mounted on the cube, you will then place a second strip of fabric tape on the first stick over the edge of the first fabric square.
- 5). Press the edges of fabric square number two over the exposed fabric tape.
- 6). Stretch and press nylon fabric square number two over square and fabric tape.
- 7). Repeat steps 4 through 6 four times, leaving one square with no nylon fabric covering.
Preparation
Prepare and Attach the Fabric
SHARE